How To Install Those Soundless Humidifiers:Part 1 !!!

Installation of soundless humidifiers in you BH do need some proper steps.

These steps will ensure the proper operation of this superd gadget.

I hereby assemble some of those important pictures for all to consider.

For Part 1 the pictures shows you how to connect the inlet water and the excess water.

Please look at enjoy the pictures (Double Click on any of these pictures for clearer view):

General overview of three humidifiers being installed. Firstly you need to get a normal sitting stool to give some hight to the unit. This is essential when you need to ensure that those excess water can easily be drained using gravity.

Note you need a filter water from you water source. For normal tap water you use one filter. For water from a waterwell or rain water you need to use two filters. A normal standard water filter is adequate. Main purpose is to prevent any accummulation of dirt or scales on those ceramic ultrasonic generating plate.

To drain any excess water from the unit, it is advisable to install a drain water pipe. U connect the drain water pipe to the drain pipe from the humdifier. To get proper gravity drainage this special pipe can be mounted on the wall just at the back of the stool and make sure there is enough gradient to allow gravity to drain the water to the outlet. Recommended angle is 5*.


For the first unit in the row you do need a single connector and not those T joint.

You can easily buy them from any shop selling water filters. Price around rm1.50 each. Since you are there get a few meters of those tubings for water input and water outlet. U need about 100 feet for a 70 X 20 feet floor. If your building pipe is not far away or the toilet is nearby you need lesser length.